[Steve]

I had it square. This is junk. Can the VW CV joint 8mm XZN be used or is it to long?



If I can get a purchase on it perhaps a vice grip on the head would work. I have new screws to install with.

Partial Post: Please Login or Register to read the full post.

[flash]

crap - i was in pasadena day before yesterday - i could have stopped by to see what was going on



no idea about the vw stuff



did you buy the vim stuff, or something else? i haven't had problems with the vim (yet)



sorry

Partial Post: Please Login or Register to read the full post.

[Steve]

The tools are VIM but it files like junk. I was able to take off 1/8" in about a minute. I will get the screws out some other way and try to use the driver to tighten and torque only.

Partial Post: Please Login or Register to read the full post.

[Steve]

If any of you are going to do this job, the 8mm Triple Square from Pep Boys or some other auto parts stores will do just fine. Snap-on and Mac also have a 3/8" drive socket but they don't working on weekends normaly hence the Pep Boy tool.

BTW, if you want a better discussion on this just go to http://forums.pelicanparts.com/showthread....492#post3178492

Partial Post: Please Login or Register to read the full post.

[Steve]

Okay so I got it all put back together but now I have no peddle. I bled the line and tryed to adjust the peddle. No luck. I adjusted until the saft left the peddle pivot. Anyone else have this happen?

Partial Post: Please Login or Register to read the full post.