[jferraro17]

I ham-fisted a wire brush while cleaning a front caliper, and tore a cylinder dust boot.  I've got a replacement, but can't figure out how to get the ripped one off.  Can I pry it out, and snap the new one in,  or does the cylinder need to be pulled out?

Partial Post: Please Login or Register to read the full post.

[Bulti]

Maybe Nathan can help you out?



http://youtu.be/9EIVWoYy0ug

Partial Post: Please Login or Register to read the full post.

[Krister]

You should be able to replace it without removing the piston. Trickiest is to keep dirt out and to clean surface after old dust boot.

Partial Post: Please Login or Register to read the full post.