I'm looking for some advice on replacing my 968’s cylinder head in my garage. I have a refurbished, decked and checked cylinder head that I would like to install on my 968 in my garage/workshop while doing a complete front end reseal/water pump/belt(s) /roller service….I have all the tools/parts for the reseal/belt job including the Anworx kit. I have done a lot of work on my 968…most recently RMS/flywheel/clutch….but I have never swapped out a cylinder head.
To the point, I have read all the available reference material and very informational message boards on this topic and based on some of the more technical information about pressurizing the variocam and some other timing issues….is this a DIY….or should I leave this one to the pro’s? I need some practical advice/tips. Thanks in advance for taking a moment to respond.
