Posts: 183
Threads: 13
Joined: Feb 2013
Reputation:
0
So in the process of replacing the bulb on my outside temp gauge, I managed to break the tabs holding the hazard switch on and one of the fins on the cover to the interior temp sensor...great :/
Anyways, also in the process I pulled the hose that goes to the behind that cover and the rubber hose popped off from deep in the dash....where does this hose connect to? I couldn't see very with the limited space of only taking the thin dash trim piece off but I still couldn't see where I have to connect it to. Is this something I should be able to reconnect or will it involve tearing the dash apart even more?
Only good news from the project is I can see my temp gauge in the dark now <img src="/forum/images/smilies/968/smile.png" class="smilie" alt="" />
1972 914 2.0 Signal Orange
1992 968 Coupe Polar Silver
1998 Civic (DD commute beater)
"Life is too short to not drive a Porsche daily"
Posts: 242
Threads: 15
Joined: Jul 2013
Reputation:
0
It connects to the dash to the little round thing that has a grille on it in the front at the dash, and in the rear (towards the firewall), it goes way back there. It would probably be easiest to remove the glove box to hook it back up if you can't get back there. The glove box just has screws holding it in.
Hope this helps.
93 968 Coupe Six Speed
73 Alfa Romeo Spider
07 Audi S8
Posts: 183
Threads: 13
Joined: Feb 2013
Reputation:
0
Helps greatly...thanks, and no wonder I couldn't see where it connects since from the angle I was looking, it would be below the ducting.
1972 914 2.0 Signal Orange
1992 968 Coupe Polar Silver
1998 Civic (DD commute beater)
"Life is too short to not drive a Porsche daily"