[Harvey]

For some reason my Check Engine dash light does not work, making it impossible for me to read the fault codes. Rather than remove the dash to replace bulbs, in the short term, couldn't I just identify the right wire from the DME controller and tap into it with a light or volt meter and read the pulsed code? If light, what amperage are the dash lights? Has anyone done this?



Thanks.



Harvey

Partial Post: Please Login or Register to read the full post.

[Greimann]

I would thnk that could work. Look at the attached pin out diagram. It looks like pin 21 is the one.

968_DME_pin_outs.pdf Size: 16.1 KB  Downloads: 15

Partial Post: Please Login or Register to read the full post.

[Eric_K]

I wonder if a previous owner removed the bulbs to mask some problem.



Eric

Partial Post: Please Login or Register to read the full post.